Battery Pack Tester
| Parameters |
| Test medium: | Compressed air or specified medium by customers
|
Gas source:
| 0.4-0.8MPA (clean, dry) |
Power supply:
| AC220V(±15%),50HZ,ground lead |
Environmental temperature:
| 0-50℃ |
Environmental humidity
| ≤95% (not dew)
|
Pressure adjustment range:
| 0-3Mpa |
Number of test ports:
| 1 |
| Status of the tested product | With or without hole, finished or semi product |
| Pressure mode: | Positive and negative pressure |
| Pressure regulation accuracy: | 0.05%F.S/0.02%F.S (Full range accuracy optional) |
| Sensor selection range: | 0-10kPa |
Sensor precision:
| 0.1%FS |
| Pressure minimum setting unit: | 1Pa |
| Resolution ratio: | 1Pa |
| Dimension: | 335*305*285mm |
| Gross weight: | 11KG |
SLA leak test detector is mainly used for scientific experiments in
the laboratory or for the full inspection of the product in the
production line. It can be independently used as a testing station,
operated manually; or fused with the automatic line body to become
one of the testing stations, which can be operated automatically.
The leak detector takes clean and dry compressed air as the
detection medium, and through a series of automatic detection,
analysis and calculation processes, such as pressure sensor,
precision pressure regulating valve, calculation unit and so on,
the determination of the good and bad of the tested products is
completed.
SLA leak test detector has the function of automatic calculation,
automatic learning, automatic calibration, also with bar code
scanning, remote control and other functions, real achieved the
intelligence and simplification.
In the process of actual production and scientific experiment,
instead of the traditional method of actual water bubble test and
pressurized water bubble, the advantages of non-destructive, fast,
data-based and scientific in testing process and results are
realized.
The passive execution standard of SLA leak test detector is based
on the actual test data and experimental test results to support
each other, so must not be misled, or into misunderstanding.
SLA leak test detector allows only a positive misjudgment. That is,
products that fall within the critical point of the criteria may be
judged as bad, but they will never be qualified. (The critical
point of evaluation criteria is theoretically eternal, so need to
be upgraded to minimize critical mass in actual production)
LEAK TESTING is an important quality control test in the
manufacturing industry. Since there is no such thing as a
completely leak-free component, the key is to determine what leak
rate is acceptable in order to manufacture products that are safe
and adequate for the customer’s needs.
